Printer: Creality Ender-3 S1 Pro (Code: M420 S1 Z10 ;Printer uses bed mesh)
Filament: CR Series 3D Printing Filaments (Diameter = 1.75mm)
Colors Used: White / Black / Grey

================================================================================

• Print Parameters:                  • Tolerances:
  - Layer Height: 0.2mm                - Pins & pin holes: 0.25mm (Too Loose)
  - Infill: 30%                        - All depth of all holes: 1mm (Pin Length Shortened)
  - Adhesion: Skirt                    - Fan blades to fan disk: 0.25mm (Too Loose)
  - Shell: 3 Layers                    - Fan disk to motor hub: 0.25mm
  - Nozzle Temp: 200C                  - Motor cooling fan to motor: 0.1mm
  - Bed Temp: 60C

================================================================================

Mass Required:
• Black: (Total Mass = 69g)
         (Total Time = 14h:24m)
  ------------------------------------
  - Spinner Cone  (-15g) (01h:48m)
  - Fan Blade     (-54g) (12h:36m) X18

========================================

• White: (Total Mass = 1075g)
         (Total Time = 118h:04m)
 ----------------------------------
  - Front Body (127g) (14h:11m)
  - Main Body  (650g) (71h:12m)
  - Back Body  (269g) (28h:03m)
  - Large Pin  (-20g) (03h:03m) X12
  - Small Pin  (--9g) (01h:35m) X22

========================================

• Grey: (Total Mass = 361g)
        (Total Time = 45h:28m)
  --------------------------------------
  - Front Body Tip      (-44g) (05h:23m)
  - Fan Disk            (-19g) (03h:03m)
  - Motor Support Cover (-11g) (01h:44m)
  - Motor Cooling Fan   (--9g) (01h:27m)
  - Front Exhaust       (107g) (12h:51m)
  - Back Exhaust        (-46g) (06h:16m)
  - Engine Support      (125g) (14h:44m)